Cabeamento dois roteadores
Comprei dois roteadores xx230v, ambos estão atualizados na ultima versão da firmware, fiz a configuração do primeiro roteador na qual está recebendo a net da operadora, configurei tudo certinho: Gpon, Slid, vlan, tudo ok, internet funcionando, porém quando eu vou configurar o segundo roteador, eu plugo o cabo de rede no primeiro roteador e no segundo, simplesmente não acende as luzes da porta lan, nenhum dos dois roteadores, mas quando eu plugo o cabo de rede de um roteador no computador, a conexão é aceita, e fiz esse teste nos dois roteadores, ambos as portas lan dos roteadores estão funcionando, só não funciona quando conecto o cabo de rede entre si e não tem comunicação, tem alguma configuração para que aceite essa comunicação via cabo de rede?
Hello @Renan-Santos ,
Welcome to our community.
According to Google Translate, your question is that you failed to set up the second router. If there is any discrepancy, please describe it in English.
If you only want to expand the network via Ethernet cable, please connect the cable to the LAN4/WAN Ports of the second router.
For the Internet Connection Type option, please select Dynamic IP.
It is recommended that you can change it to Access Point mode to avoid double NAT. Please refer to BBA GPON_User Guide (from page 44)
But if you want to create an EasyMesh Network, please note that XX230v cannot work as an agent. So you can consider replacing it with another device that supports agent mode in the EasyMesh network.
Best Regards.
@Joseph-TP Thanks for the answer, I did the tests here, but I didn't get any results, because on the first router, I configured everything correctly, I left it as an access point, and the internet is working, on the second router, I put the network cable in port 4 (lan/wan) and I'm not having success, because the router simply doesn't have communication with the first router, remembering that I have two routers of the same model, the xx230v
Joseph-TP wrote
Hello @Renan-Santos ,
Welcome to our community.
According to Google Translate, your question is that you failed to set up the second router. If there is any discrepancy, please describe it in English.
If you only want to expand the network via Ethernet cable, please connect the cable to the LAN4/WAN Ports of the second router.
For the Internet Connection Type option, please select Dynamic IP.
It is recommended that you can change it to Access Point mode to avoid double NAT. Please refer to BBA GPON_User Guide (from page 44)
But if you want to create an EasyMesh Network, please note that XX230v cannot work as an agent. So you can consider replacing it with another device that supports agent mode in the EasyMesh network.
Best Regards.
Thanks for the answer, I did the tests here, but I didn't get any results, because on the first router, I configured everything correctly, I left it as an access point, and the internet is working, on the second router, I put the network cable in port 4 (lan/wan) and I'm not having success, because the router simply doesn't have communication with the first router, remembering that I have two routers of the same model, the xx230v