Home Network Community > Range Extenders > RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update
< Range Extenders

RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update

RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update

RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update
RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update
a week ago
Tags: #OneMesh #Firmware Update #EasyMesh #Web GUI Management
Model: RE705X  
Hardware Version: V1
Firmware Version: 20250627

Topology: 1 x AX5400 router, 4 x RE705X easymesh extenders

 

I have upgraded firmware on 3 of the extenders from 20230509 to 20250627.  All our used to show medium to strong signal strength prior to the firmware upgrade.  The three extenders that I upgraded now show 1 red bar in the AX5400 management page.  The fourth, which is still running the old firmware, continues to show a strong signal.

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update
Wednesday

Hello @Gausie ,

Welcome to our community.

 

Are the clients on these satellite units working normally? Please reboot the whole EasyMesh Network for a try. 

Also, can you check the signal strength via the Tether App for comparison?

 

Thank you.

Check Out the Latest Posts: △ Pre-release Firmware for Archer AX50 Introduces New Parental Control Features and Enhancements △ Pre-release Firmware for Archer AX80 Supports EasyMesh in AP Mode, DoH/DoT, ECO Mode, and More △Introducing AI QoS: Elevate Your Gaming Experience on the Archer GE800 Gaming Router △Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN △ Tether KidShield Test Recruitment - Safeguarding Children's Online Experience
  0  
  0  
#2
Options
Re:RE705x mesh Main Network Signal strength showing incorrectly on AX5400 after firmware update
Wednesday

  @Joseph-TP 

 

Hi Joseph - and thanks for your welcome and reply.

 

I have just rebooted both the AX73 and the RE705xs.

 

The NetworkMap->MeshDevices page on the router still reports the same issue.

 

The network works fine.  Tether shows 3 bars on all but one of the extenders, which shows 2 bars.  The "2 bar" extender is the furthest away, and is still on version 1.1.4.  The other extenders have all been upgraded to 1.2.10.

 

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 724

Replies: 2

Tags

OneMesh Firmware Update EasyMesh Web GUI Management
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.