Home Network Community > DSL Modem&Routers > Archer D2: how can I disable NAT ?
< DSL Modem&Routers

Archer D2: how can I disable NAT ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer D2: how can I disable NAT ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer D2: how can I disable NAT ?
Archer D2: how can I disable NAT ?
2015-11-28 01:56:38
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

My current internet connection has a public subnet /30 for the WAN interface, and a public subnet /29 for the LAN interface. I usually configure the routers for this kind of connection disabling NAT, because I need to use the public subnet /29 attached to the LAN.

But I cannot find a way to completely disable NAT on the Archer D2.

How can I disable NAT on the Archer D2 ?
  0      
 
  0      
 
#1
Options
2 Reply
Re:Archer D2: how can I disable NAT ?
2015-12-01 03:12:02

How can I disable NAT on the Archer D2 ?

I have only one idea, setup your router as a bridge.
  0  
  0  
#2
Options
Re:Archer D2: how can I disable NAT ?
2015-12-01 21:42:23
In the advanced settings, under the second "advenced" group, there is a NAT enable item. I disabled it but really, this Archer D2 does not work in this configuration.

I changed the router with a netgear D1500, configured with IPoA+LLC on the wan and private subnet on the LAN, no nat, and in 5 minutes it was UP and running :(

Thank you for answering.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 3534

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.