Need to switch from main to satellite deco be5000
I configured one deco be5000 as main, but after having some trouble i configured a second one as main and then a satellite one. These two are working great. I am trying to configure the first one as satellite but I get: yellow and then solid red, no matter how hard I press the reset button. How can i configure this one to satellite
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@David-TP hello sir, IT WORKED! Thank you so very much! I connected near to the main, press rest for one second and waited, it went from yellow to blinking blue, solid blue and then green!!!!! I disconnected it and placed it far from main and it got green again!!!! Thank you very much! You know this stuff!
- Copy Link
- Report Inappropriate Content
Hi, usually the factory reset only needs to press the reset pinhole for 1s.
Here are some suggestions for your reference:
- Swap the power adapter of this unit with another BE5000.
- Put it next to the new main Deco
- Hold the reset pinhole again for 1s only
- Check whether the LED could turn to flashing blue
However, if it was still red, can you detect its default SSID, such as "Deco_xxxx"?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
@David-TP hello sir, IT WORKED! Thank you so very much! I connected near to the main, press rest for one second and waited, it went from yellow to blinking blue, solid blue and then green!!!!! I disconnected it and placed it far from main and it got green again!!!! Thank you very much! You know this stuff!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 83
Replies: 2
Voters 0
No one has voted for it yet.