HI, I have an NX510v as a master unit. I also have two AX23 routers as mesh units. One AX23 router is connected via a 1Gbps LAN cable. The other is via wifi. How does the NX510v determine whether it is using LAN or wifi? The first router sometimes connects via wifi by itself and ignores LAN. I measured the cable and there are no outages when watching videos. Sometimes it happens that the entire network becomes unstable due to the reconfiguration of the LAN wifi on the AX23. I usually have about 30 active devices with a small data flow connected there. But it is annoying because devices that are primarily via wifi reconnect. Both X23 mesh have the same fw (latest version). You cannot upload any fw to the NX510v because it is from the operator and they determine the version. Why can't you set a thoroughly tested connection option for mesh routers? This unnecessarily causes problems on the entire network.