Archer D2:cannot see wired clients on Network Map
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer D2:cannot see wired clients on Network Map
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Model Number: Archer D2
Hardware version: Archer D2 v1 00000000
Firmware version: 0.8.0 1.1 v003e.0 Build 150730 Rel.62022n (latest)
ISP: Telecom Italia
Hello,
I have Archer D2 connected to my home network.
Some clients are wired, some others are wireless.
On the Network Map I can see only the wireless client but not the wired.
Wired clients are:
1. Network Disk (NAS)
2. Set top Box (Satellite receiver)
3. Other Access points (2)
All of them have got a Static IP and I have reserved the IP for them, associating to MAC address.
DHCP is active (but only form 192.168.0.50 to 192.168.0.99) and Static IP clients have IP lower then 192.168.0.50
The clients can anyway connect to the router and also to the internet but sometime the connection is lost and I have to reset the client.
Thanks for your support.
Regards
ugo
Hardware Version : Not Clear
Firmware Version :
ISP :
Model Number: Archer D2
Hardware version: Archer D2 v1 00000000
Firmware version: 0.8.0 1.1 v003e.0 Build 150730 Rel.62022n (latest)
ISP: Telecom Italia
Hello,
I have Archer D2 connected to my home network.
Some clients are wired, some others are wireless.
On the Network Map I can see only the wireless client but not the wired.
Wired clients are:
1. Network Disk (NAS)
2. Set top Box (Satellite receiver)
3. Other Access points (2)
All of them have got a Static IP and I have reserved the IP for them, associating to MAC address.
DHCP is active (but only form 192.168.0.50 to 192.168.0.99) and Static IP clients have IP lower then 192.168.0.50
The clients can anyway connect to the router and also to the internet but sometime the connection is lost and I have to reset the client.
Thanks for your support.
Regards
ugo