@grakeshk 

Hi,

Before you attempted the pairing via WPS, did you put the BE805 into the proper mode to be added as a satellite?

(What I mean by that is to either Factory Reset the BE805 or switch it to "Satellite Mode" by clicking on "Change Mode" within the "EasyMesh" menu, both of which resulting in the same thing.)

Hi   @woozle , 

After I did a reset and did WPS, the blue light is constantly blinking , however I see in the Aginet App that is already in the network. but its not accepting connection from the device.

May I know where can I setup satellite mode usiung change mode? Please advise

  @grakeshk 

If the BE805 shows up in the Mesh of the EB801V, then it is already added to the network. There must be another problem preventing it from being accessible.

In case you have activated the "Band Steering" option on the EB801V, then switch it off and try again. Some Archer routers may not connect properly if that option is used.

The change to Satellite Mode will also just do a Factory Reset.

Anyway, the "Change Mode" option is in the "Advanced" -> "EasyMesh" menu of the BE805.

 Hi @woozle,

I was able to include the BE805 in the network after factory reset and multiple restarts. Now the LED light is solid blue. The issue now is no device is getting connected to BE805, the devices are connecting to only EB810V only.  

Note : The band steering is on. Are there any other settings to be changed ? I thought the easymesh supposed to be simple and handle the mesh and devices very well.