RE655BE problem after 1.1.3 update
Hello,
I use RE655BE as an easymesh repeter, controled by a BE800 router.
After updating to 1.1.3, I encounter big problem with my network if the RE655BE is on.
The network become as unstable as I can't access BE800 or RE655BE. Accessing my nas, VM.. is really difficult too. Mainly not possible.
I try using a wired or wifi connection between them, but nothing changed.
I reset le RE655BE and the problem is still here.
What can I do ?
Regards,
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If you suspect the culprit is the new FW release then you can downgrade the FW to the previous release from here and then test the stability of your local network.
The downgrade procedure is the same us upgrade procedure, just using an older FW release.
- Copy Link
- Report Inappropriate Content
Hello @Fredx_xda ,
Welcome to our community.
May I know if your network topology diagram is as follows:
ISP modem—BE800 —RE655BE in AP mode )))((( client devices
(Note: — stands for wired connection,)))((( stands for wireless connection )
Is there a switch between the BE800 and RE655BE? If yes, please remove the switch for a try.
Or, remove the RE655BE to see if the network can run on the BE800 again.
Recently, have you changed any settings on the BE800? Like a firmware update. And what are the firmware and hardware versions of BE800?
- Copy Link
- Report Inappropriate Content
Hello @Joseph-TP.
The ISP modem is configured as bridge. The BE800 acts as DHCP server, ...
When removing the RE655BE the network run again.
I am not able to reach the admin console of both BE800 and RE655BE when the last one is in the network. I'll try to reset it a second time and downgrade the firmware.
Joseph-TP wrote
Hello @Fredx_xda ,
Welcome to our community.
May I know if your network topology diagram is as follows:
ISP modem—BE800 —RE655BE in AP mode )))((( client devices
(Note: — stands for wired connection,)))((( stands for wireless connection )
Is there a switch between the BE800 and RE655BE? If yes, please remove the switch for a try.
Or, remove the RE655BE to see if the network can run on the BE800 again.
Recently, have you changed any settings on the BE800? Like a firmware update. And what are the firmware and hardware versions of BE800?
- Copy Link
- Report Inappropriate Content
Hello @Fredx_xda ,
You mentioned that you have created an EasyMesh network between the BE800 and RE655BE, right?
What if you disable EasyMesh?
Please set different SSIDs for BE800 and RE655BE to determine whether the disconnected clients were connected to the BE800 or RE655BE
In addition, what is the firmware version of your router now? Is it the pre-release firmware 1.4.1?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3727
Replies: 4
Voters 0
No one has voted for it yet.