IPv6 Adress or DNS is not downloading
Hi,
Despite following your guide for setting IPv6 with dynamic IPv4 and settings that ISP suggested in IPv6 submenu, router cannot correctly update IPv6 address or DNS, my current setup is Technicolor modem/router used in bridge mode, my ISP is polish Vectra, connected correctly to my BE550, i also tried non-address setting but without success. I asked ISP if i have IPv6 enabled and they said i do. Do you have any ideas what could cause this?
Thanks in advance!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Eariler I switched Technicolor into bridge mode remotly form vectra website so i couldn't access anything of it's settings, after i switched back to open and set bridge there IPv6 started working despite no settings available there at all besides router/bridge mode and enabling/disabling of WiFi.
Last settings of IPv6 that i had on tp-link was standard ones beside non-address way of getting ipv6 address, so i don't think i will be changing that since all network tests show fully correctly working IPv6.
Thanks for help!
- Copy Link
- Report Inappropriate Content
Hi,
Do you have a computer with Ethernet port available?
If yes, then unplug the Ethernet cable from the WAN port of the BE550 and then plug that same cable into the Ethernet port of the PC (so that the PC is connected to the Technicolor). Can the PC acquire a proper IPv6 address? (usually something that begins with 2a**:***)
- Copy Link
- Report Inappropriate Content
I checked both on Windows and Linux, public IPv6 doesn't show up, but Technicolor router/modem is in bridge mode as it should be, and ISP says IPv6 is enabled, what should I do next?
- Copy Link
- Report Inappropriate Content
Have you already checked whether there is anything IPv6-related shown in the settings menu of the Technicolor modem? Like, look for an IPv6 on/off switch in all the menus or see if there is at least a "Status" page that contains any IPv6 information.
- Copy Link
- Report Inappropriate Content
Eariler I switched Technicolor into bridge mode remotly form vectra website so i couldn't access anything of it's settings, after i switched back to open and set bridge there IPv6 started working despite no settings available there at all besides router/bridge mode and enabling/disabling of WiFi.
Last settings of IPv6 that i had on tp-link was standard ones beside non-address way of getting ipv6 address, so i don't think i will be changing that since all network tests show fully correctly working IPv6.
Thanks for help!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 92
Replies: 4
Voters 0
No one has voted for it yet.