LAN only not supporting wired ethernet devices
I have a TP-Link Deco XE5300 (not recognized in the product model field for this post).
My internet service recently went dark. I disconnected the WAN cable and was trying to continue to use my network locally, but none of the devices plugged into the Ethernet ports were recognized any longer. I even tried plugging my laptop directly into one of the ports (rather than a switch) and it was disconnected, even after rebooting the Deco stations. How do I get the wired LAN devices to be recognized again? I need connectivity between my wired devices and I need DHCP to give IP addresses.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, can you send an email to support.forum@tp-link.com?
(Please add forum ID 859056 in the subject.)
There hasn't been a beta firmware for Deco XE5300_V1. I'll need to check with the senior engineer for further assistance.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, can I have the current firmware version of the Deco XE5300?
If it is 1.3.1 Build 20251023 Rel. 43624, it is recommended to install the 1.4.999 beta here, which allows fixing the WAN port:
Firmware 1.4.0 for Deco XE75/XE5300/XE75 Pro_V2/V3 Added Wi-Fi Access Control, WireGuard VPN & More
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
thank you David. My firmware is version: 1.4.5 Build
20241129 Rel. 44718
is there a workaround?
- Copy Link
- Report Inappropriate Content
Hi, can you send an email to support.forum@tp-link.com?
(Please add forum ID 859056 in the subject.)
There hasn't been a beta firmware for Deco XE5300_V1. I'll need to check with the senior engineer for further assistance.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
They've just released a brand new beta firmware for the following Deco models:
Applies to:
- Deco XE75 V1
- Deco XE75 Pro V1
- Deco XE5300 V1
Please make sure your hardware version is either V1 or V1.6 by using the following FAQ.
If you want to test it out, you can read more about it using the link below. If you encounter any problems with the beta, please report them using the same link found below.
Deco XE75/XE75 Pro/XE5300 V1 Pre-Release 1.5.0 Brings WireGuard VPN, DoH/DoT, LED Scheduling & More!
Thanks.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 305
Replies: 4
Voters 0
No one has voted for it yet.