TD-W9960v - Auto disconnect/reconnect doesn't work
Hi, the option "Auto disconnect and reconnect at(HH:MM)" for PPPoE connections under "Advanced >> Network >> Internet >> Add" doesn't work.
The router's system time is correct but there is no disconnect and reconnect at all.
Might this be a firmware bug?
BTW: When a third party call is prompted the callers phone number doesn't show up on the display of a phone connected via TAE. Is there a way to get that working?
Thanks for help.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @Sir_Vival,
Welcome to our community.
Here is a firmware that may help: TD-W9960vV1_1.9.0_0.8.0_up_boot(241219)
Manually updating the firmware, please refer to How to upgrade firmware of TP-Link xDSL Modem Router.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hello @Sir_Vival,
Welcome to our community.
Here is a firmware that may help: TD-W9960vV1_1.9.0_0.8.0_up_boot(241219)
Manually updating the firmware, please refer to How to upgrade firmware of TP-Link xDSL Modem Router.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hello, the firmware update obviously failed. All lights of the router are off. It seems to be bricked.
Is there a way to recover?
- Copy Link
- Report Inappropriate Content
Hello @Sir_Vival ,
Please try:
- Plug the modem router into a different electrical outlet.
- Use a different power adapter.
If it doesn't help, perform a factory reset: Use a pin to press and hold the reset button for about 6–10 seconds until the lights briefly turn on, then release and allow the device to reboot.
For further assistance, please contact local support.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 212
Replies: 4
Voters 0
No one has voted for it yet.