Wired client not appearing in web management page or aginet app
I am currently using 2x TP Link HB710 that came with my Singapore MyRepublic as my ISP. It's currently operating in Router mode, where the main router 10G LAN Port is connected to DLink F206XT switch, the 2nd HB710 are connected to this switch through ethernet wired backhaul connection. I have added the 2nd HB710 as a easymesh agent, not controller via the aginet app and the ethernet cable was connected after.
I cannot see my PC which is connected via the switch, via ethernet 6e cable. If I disconnect the ethernet wired backhaul of the 2nd HB710, the wired client reappears.
Will this affect my PC internet connection in any way?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
"I cannot see my PC which is connected via the switch, via ethernet 6e cable."
-When this happens, does the PC obtain an IP address? Can it access the internet? You can refer to the following FAQ to check the IP address info on the PC: How to find your IP address on Windows OS
If you connect the PC directly to the 2nd HB710, will it display correctly in the Aginet app or HB710's web management, and will it have internet access?
Best Regards
- Copy Link
- Report Inappropriate Content
@smgoh6 my pc is able to connect to the internet when connected through the switch using cat 6e cables, i am able to see the IP address for my PC. i have not tried to connect to the 2nd hb710 as the distance can be quite far and will need a long ethernet cable for connection.
previously i faced issues with "No DHCP server found" periodically for my PC connected through the switch using cat 6e cables but back then, my 2nd hb710 was also operating as a controller (router mode) so i figured this was the root cause of the "No DHCP server found" problem faced on my PC.
just want to make sure i dont run into "No DHCP server found" issue for my PC
- Copy Link
- Report Inappropriate Content
Hi,
I'm confused about your description. Please confirm if the following information is correct.
When the two HB710 nodes form a mesh network with the topology "internet--1st HB710 -- D-Link switch -- 2nd HB710", if the 2nd HB710 operates as a controller (router mode), the PC connected to the switch periodically encounters the "No DHCP server found" error. If the 2nd HB710 operates as an easymesh agent, the PC has an internet connection, but does not appear in the Aginet app.
Best Regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 126
Replies: 4
Voters 0
No one has voted for it yet.