[TD-W8970] Problems with time settings/NTP Server after power break down

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[TD-W8970] Problems with time settings/NTP Server after power break down

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
[TD-W8970] Problems with time settings/NTP Server after power break down
[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-17 20:53:20
Model : TD-W8970

Hardware Version : TD-W8970 v3 00000000

Firmware Version : 0.9.1 1.2 v0035.0 Build 150427 Rel.63930n

ISP :

If I have a power break down the time setting is going wrong.

It seems also that the NTP Server doesn't work. My entries are: at.pool.ntp.org and server0.pool.ntp.org

Do you have an idea what is wrong?
  0      
  0      
#1
Options
6 Reply
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-19 01:38:23
What is the router operation mode? Do you have WAN address on the router?
  0  
  0  
#2
Options
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-19 01:47:28
I don't have a WAN Adress, is this the problem?

Operation Mode:
DSL Modem Router Mode

Connection Type: [B]Bridge[/B]
  0  
  0  
#3
Options
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-19 01:50:11
Yes this is the main problem.
  0  
  0  
#4
Options
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-20 14:00:04
...and no workaround?
  0  
  0  
#5
Options
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-09-20 23:56:02
I don't know any solution. GMT receives data from WAN port. So it is written the firmware.
  0  
  0  
#6
Options
Re:[TD-W8970] Problems with time settings/NTP Server after power break down
2016-12-16 03:02:06
I too have this issue. I have the TL-WR841N set up as an access point with the WAN connection empty.
As per the above, all attempts to use NTP time servers are unsuccessful.

My suggestion is to add to the "Time Settings Help" pane to indicate that "Get GMT" will fail in modes that don't use
the WAN connection, such as AP mode. Or better yet, change the firmware to support those modes.
Thanks.
  0  
  0  
#7
Options

Information

Helpful: 0

Views: 1136

Replies: 6