VR900 v1, missing IPV6 address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VR900 v1, missing IPV6 address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR900 v1, missing IPV6 address
VR900 v1, missing IPV6 address
2016-11-16 17:06:11
Model :

Hardware Version :

Firmware Version :

ISP :

Hi,

I just noticed recently while looking up my IPV6 address that it's not shown properly in the router settings, instead of the IP all that is shown is:




As shown in the below screenshot my system is fully IPV6 enabled.





I am running the latest firmware.
  0      
  0      
#1
Options
2 Reply
Re:VR900 v1, missing IPV6 address
2017-02-06 23:19:06
the VR900 does nto support IPV6 from BT or other VDSL providers in the UK as the UK is using a /56 prefix which is not supported by TP-Link VR900 devices. Until TP-LINK provide their user community with an upgrade, the IPV6 on the VR900 will never work correctly.
  0  
  0  
#2
Options
Re:VR900 v1, missing IPV6 address
2017-02-09 08:25:28

yakuzah wrote

the VR900 does nto support IPV6 from BT or other VDSL providers in the UK as the UK is using a /56 prefix which is not supported by TP-Link VR900 devices. Until TP-LINK provide their user community with an upgrade, the IPV6 on the VR900 will never work correctly.


I've come to the conclusion via this forum and others that it was a mistake to buy a TP-Link product, when I purchased my router it was relatively expensive and performance wise isn't any better than the budget one I was using previously. Their lack of support is abysmal.

I bought a recondition Netgear WNDR3700 dd-wrt for a third of the price of the VR900 and it outperforms it in every way.
  0  
  0  
#3
Options