Which powerline to extend TL-WPA4220kit?
Which powerline to extend TL-WPA4220kit?
I've a TL-WPA4220kit (300Mbs AV500 wifi), to extend this kit, which poweline I've to buy to have other 1 or 2 node?
Thank's in advance for any indications
Best Regards
Max
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Ok, I've buyed one wpa4220 but when I try to pair nothing happen. The new one after some seconds of power blinking go back to fix meanwhile the master remain in blink mode till i don't press again the pair button.
I've try to see by tpPlc but it don't see the new one.
Connected the new one to an hub I've seen the configuration and there are 2 strange things:
1) in status page my old wpa4220 has this firmware version: 1.2.9 Build 160525 Rel.35241n MAC-QCA7420-1.3.0.2134-00-20151212-CS PIB_422091_160421_003
new one has 1.2.9 Build 160525 Rel.35241n BootLoader
2) in powerline network setting the new one has mac address 00-00-00-00-00-00
Any ideas to solve it?
Thanks in advance
Max
- Copy Link
- Report Inappropriate Content
Hi,
What is the current light status of the powerline adapters? Especially the new one.
And below is the instruction to pair them manually:
https://www.tp-link.com/support/faq/258/
Note: Please move them into the same room and plug into the wall sockets directly to pair them; besides, the power led will flash once you hit the pair button for 1s.
Besides, you can reset the powerline adapters and re-pair them again.
May it help and have a nice day.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
The new 4220 has powerline led off, that is why it does not work.
Please plug the new 4220 and the 4010P into the same room and plugged into the wall sockets directly, after that, try to pair them manually.
https://www.tp-link.com/support/faq/258/
Note: Please ensure that the power light flashes once you press the pair button for 1s.
Good day.
- Copy Link
- Report Inappropriate Content
Hi Kevin,
I agree with you that powerline led off mean that is not paired but,
if I try to pair the 4010P remain in blink meanwhile the 4220 after a couple of second from blink go to stable on
if I try to see 4220 from tpPLC is not viewed
if I try to add it by key, tpPLC says that can't add it
I have followed all the guide from tp-link and I have also compared both 4220 and the only difference is the firmware and that new one don't has mac address on Powerline page..
Best regards
Max
- Copy Link
- Report Inappropriate Content
Hi Max,
Have you ever tried to move them into the same room and plug them into the wall sockets directly to pair them?
Meanwhile, you can reset all the 3 adapters and re-add them via the tpPLC utility and give it a shot.
Any updates, please let us know.
Good day.
- Copy Link
- Report Inappropriate Content
Yes,
they stay in same room, plugged to wall, and an distance of 1 meter
Today I'll try to reset all 3 plug
Best regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3517
Replies: 15
Voters 0
No one has voted for it yet.