Flashed Firmware for other Hardware Version

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Flashed Firmware for other Hardware Version

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Flashed Firmware for other Hardware Version
Flashed Firmware for other Hardware Version
2019-03-16 12:57:53
Model: TL-PA4010 KIT  
Hardware Version: V2
Firmware Version: 1.3.1.0

Hi, today i upgraded the firmware of my TL-PA4010KIT V2.2 to 1.3.1.0 but i wasn't aware of the fact that i had to flash the firmware for V2, so i flashed the one for V4.

So far i haven't encountered any problems, but i just wanted to know if there are any compability issues between the firmwares for V2 and V4. I have also tried to flash the old firmware for V2, but i always get the error "Failed to upgrade" in the tpPLC utility.

  0      
  0      
#1
Options
1 Reply
Re:Flashed Firmware for other Hardware Version
2019-03-18 11:10:52

Hello,

 

for your information, the firmware should match the hardware, otherwise, it may ruin the powerline adapter.

 

Cause the current units work properly, it is not suggested to flash the firmware back to V2. 

 

You can run the powerline adapters with the current firmware.

 

Good day. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options