Archer 59 Multicast problem
Hi, I have an archer c59 v1 and multicast channels won't work.
What I've already tried:
- Connect the STB directly to my ISP modem and it worked.
- Asked my ISP to remove bridge mode to their modem/router and use it as router and multicast channels work.
- Configure IGMP in the admin panel, with v3 as that is the version my ISP uses. Not worked.
- Add my STB to DMZ. Not worked.
- Turn off firewall or any other security meassures. Not worked.
I don't know what else to do or try. Please don't send me to the "How to configure IGMP" page because I've already done it.
Any ideas?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Does STB mean set top box? If so, it may has something to do IPTV function, you can enable it and give it a go.
Below is the instruction to set it up.
https://www.tp-link.com/en/support/faq/1538/
Any updates, please let us know.
Nice day.
- Copy Link
- Report Inappropriate Content
I did, the thing is that the STB is not only IPTV or Internet, it has both. Some channels go over the internet, are pure OTT. All the backoffice information goes over the internet.
I've tried both configurations and none worked.
- Copy Link
- Report Inappropriate Content
Hi,
Could you please do a test and show us some details.
1. Please setup the IPTV function and connect the STB to the IPTV port.
Note: Please show us the screenshot of the IPTV settings page.
2. After that, please check the IP address of STB, and try to ping the router's gateway.
Note: Please show us the IP address and the ping results.
Good day.
- Copy Link
- Report Inappropriate Content
This is my config: https://imgur.com/WWCaEJu
This is the result: https://imgur.com/Yrl2GSN
Tried this, no ping also: https://imgur.com/SmWdyer
- Copy Link
- Report Inappropriate Content
Hi,
Thanks for your reply.
If there is no VLAN settings given by ISP, then it is okay to select Bridge, while I found that all the 4 ports are internet ports.
So please change one of them to IPTV port, and connect your STB into that port to do a test. Whether it can obtain an IP address and whether it works fine.
Good day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1118
Replies: 5
Voters 0
No one has voted for it yet.