printer problems with new firmware
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
i am having printer problems with the new firmware
it seemed to lose signal and printed very very slowly
work round turned off the 2.4 gig network in the app waited 30 sec and turned it back on again printer now works ok
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Kevin
a quick update
printer is working as it should
looks like the WPS setup was the problem
you know my deco's are m5
the printer is a canon TS9150
for information if anyone else has the same problem
- Copy Link
- Report Inappropriate Content
How do you connect the printer to the Deco? By wireless or wired cable?
Try to disable fast roaming and setup QoS as standard and clear the high priority items to give it a go.
Any updates, please let us know.
- Copy Link
- Report Inappropriate Content
Kevin
printer is connected by wireless
fast roaming is off
Qos is at standard
this is how it's set up
i have rebooted the deco system and things seem better with the printer now showing some signal on it control panel
the only thing I have done is connect it manualy rather than WPS
i will post a update tomorrow after it's settled down
- Copy Link
- Report Inappropriate Content
Seems to have fixed it looks like the manual setup worked better than the WPS method
- Copy Link
- Report Inappropriate Content
Thanks for your clarification. Glad to hear that it works well now.
It is also suggested by us to connect client devices to the Deco network with wifi password cause the WPS mechanism varies due to different manufacturer.
You can keep an eye on it and take more time to test its performance.
Any further problem, please let us know.
- Copy Link
- Report Inappropriate Content
Will do
- Copy Link
- Report Inappropriate Content
Definitely sure.
Have a good day.
- Copy Link
- Report Inappropriate Content
Kevin
a quick update
printer is working as it should
looks like the WPS setup was the problem
you know my deco's are m5
the printer is a canon TS9150
for information if anyone else has the same problem
- Copy Link
- Report Inappropriate Content
Thanks for your sharing, glad to hear that the printer works well now.
You can enjoy the internet with the Deco units.
If need more help, do not hesitate to contact us.
Nice day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2042
Replies: 8
Voters 0
No one has voted for it yet.