Unable to use Ethernet Backhaul when IPTV is enabled
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I’m using Deco M5 in Router mode with latest firmware.
I have problem to use Ethernet Backhaul from main deco to slave deco when I enable IPTV/VLAN. It will always use Wireless Backhaul even I have direct Ethernet connection between main and slave deco.
I did try to disable IPTV/VLAN but it becomes no internet access in both deco.
Is there a way to overcome this?
Please help.
Thanks for reply. Please check my reply in Red.
Hello, do you have any IPTV service? Yes I do have IPTV service come with internet provider, but I do not use it so it can be disabled if needed.
Or do you connect any IPTV to the LAN port of the Deco M5? My Deco M5 have 2 ethernet port at the back. First port I use to connect my service provider modem to my Deco. Second port I intend to use it to connect to my switch to allow my network to access internet.
How did you setup the IPTV/VLAN feature? Could you please show us a screenshot? See below.
Depending on the configuration parameters the LAN port may not work for common network devices, like computer, but for IPTV service only. I try to disable IPTV, but my Deco become no internet connection if I do so.
Is it by enable the IPTV/VLAN my slave deco was unable to use Ethernet Backhaul as highlighted in screenshot below?
