reset PA8010P to factory default

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

reset PA8010P to factory default

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
reset PA8010P to factory default
reset PA8010P to factory default
2020-03-17 10:21:14
Model: TL-PA8010P KIT  
Hardware Version: V2
Firmware Version: 2.2.3.32-00_801192_170511_906

Made a mistake by changing het ip adres.

I know it stil but I cannot acces the base device anymore.

reset factory does not work. Plaase help. 

TPplc seems not to work also older versions not.

reg leon

  0      
  0      
#1
Options
1 Reply
Re:reset PA8010P to factory default
2020-03-18 09:34:06

@leon_1956 

 

Hi Leo, with the TL-PA8010Pkit powered on, press and hold the pair button for more than 6 seconds to reset the powerline adapter.

 

Then you can use the tpPLC utility to re-pair them. 

https://www.tp-link.com/support/faq/1615/ 

 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 4557

Replies: 1

Related Articles