MR400 not failing back to Ethernet after failing over to 4G

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR400 not failing back to Ethernet after failing over to 4G

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR400 not failing back to Ethernet after failing over to 4G
MR400 not failing back to Ethernet after failing over to 4G
2020-06-13 00:53:43
Model: Archer MR400  
Hardware Version: V2
Firmware Version: 1.9.0 0.9.1 v0001.0 Build 190307 Rel.45273n

I have a client that we installed a MR400 as they needed to use a 4G backup supplied by their ISP and the ISP couldn't get their provided modem to work with the 4G at all.

 

Anyway its been running for a while and all was going good until recently. I even tested failover and failback when I first installed it and it worked perfect.

 

If the device switches to 4G as a backup because the ipoe (Ethernet) internet goes down its not switching back to the ipoe when its back up. Operation Mode is set to Wireless Router Mode not 3G/4G Router.

 

Under Internet connection its set for 3G/4G to be enabled as backup However as seen the ipoe connection is back up (I have whited out the IPs obviously)

 

Yet its still using the 4G as below...

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 719

Replies: 0

Related Articles