AUTO FAILOVER in TP LINK TL-MR6400
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All,
I have purchased "TL-MR6400" but my requirement was to connect it mainly as WAN router and then it should do a auto failover when WAN is down to MOBILE NETWORK.
However Im seeing that either we can configure it as WAN ROUTER or MOBILE 3G/4G routern ( A reboot is required to swap the modes).
This is not what I was looking, Can some one tell if there are any options we can try or any other model in TP LINK?
Thanks in advance.
Manoj
Good day.
Thank you very much for your patience.
For the TL-MR6400 V2, It did not support wireless router mode with 3/4G mobile back up.
while for V3 and above, it has the wireless router with mobile back-ups, such as
Thank you very much.
Good day.
Thank you very much for your patience.
For the TL-MR6400 V2, It did not support wireless router mode with 3/4G mobile back up.
while for V3 and above, it has the wireless router with mobile back-ups, such as
Thank you very much.