Archer C6 can't see channel change option in wireless sertings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6 can't see channel change option in wireless sertings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C6 can't see channel change option in wireless sertings
Archer C6 can't see channel change option in wireless sertings
2020-09-12 04:48:06 - last edited 2020-09-14 08:39:45
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.3.5

Please help. I have setup Archer C6 as my primary router and trying to use WDS bridge on my old W740 router. When any of the router is rebooted the Auto channel setting on C6 changes the channel resulting in W740 loosing connection. The solution is to fix Channel on my C6. But the wireless settings does not show me Channel or width setting in the menu. See the snap below. 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Archer C6 can't see channel change option in wireless sertings-Solution
2020-09-13 11:11:59 - last edited 2020-09-14 08:39:45

@Pswarup I have found the relevant settings. It was my routers SMART CONNECT option once enabled it doesn't  show these properties. After disabling smart connect i now can  see the same.

 

The issue is 24 and 5 GHZ will not be auto balanced.

 

Thanks 

 

Recommended Solution
  3  
  3  
#2
Options
3 Reply
Re:Archer C6 can't see channel change option in wireless sertings-Solution
2020-09-13 11:11:59 - last edited 2020-09-14 08:39:45

@Pswarup I have found the relevant settings. It was my routers SMART CONNECT option once enabled it doesn't  show these properties. After disabling smart connect i now can  see the same.

 

The issue is 24 and 5 GHZ will not be auto balanced.

 

Thanks 

 

Recommended Solution
  3  
  3  
#2
Options
Re:Archer C6 can't see channel change option in wireless sertings
2020-09-14 08:40:21

@Pswarup 

 

Yes, you need to disable the Smart Connect first, then you can change the wireless channels for the 2.4GHz or 5GHz.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  1  
  1  
#3
Options
Re:Archer C6 can't see channel change option in wireless sertings
2021-01-28 10:23:46
please remove ;) smart connect off and can set it.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 8335

Replies: 3

Related Articles