MR 600 with external MIMO Antennas

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR 600 with external MIMO Antennas

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR 600 with external MIMO Antennas
MR 600 with external MIMO Antennas
2020-09-17 18:06:09 - last edited 2020-09-18 08:45:58
Model: Archer MR600  
Hardware Version: V1
Firmware Version:

Hello,

I have been using an MR 600 in Croatia since about a year and I am in generall very satisfied.

 

The best position of the MR 600 for a good signal sregnth is direct near to the window, but there it is heated up by the solar radiation.

If I place the router inside the room - out of the solar radiation, my reception performance not good enough. I now would like to connect 2 external MIMO directional antennas placed at the  winddow and aligne them with the next radio transmitter so that I can take the router out of the sun.

 

I now have the following question:


Does WIFI also use the external antennas and my WLAN becomes weaker with the new external antennas, or does WIFI only use internal antenna and the new external ones will have no influence on the signal strength in the builing?

 

Thanks for any replay

 

Best gregards

Moehl

  0      
  0      
#1
Options
1 Accepted Solution
Re:MR 600 with external MIMO Antennas-Solution
2020-09-18 08:44:19 - last edited 2020-09-18 08:45:58

@Moehl_99 

Good day.

Thank you very much for your time and patience.

Sorry for the delay.

For the MR600 v1, It has 2 Detachable External LTE Antennas, and Wi-Fi antennas are internal;

And the LET antennas are RP-SMA male, but normally it is recommended to always use the original antennas and if they have to be replaced, please replace them all together;

 

Since the Wi-Fi antennas are internal, so there is no way to improve the signal by changing the antennas;

But you could try to modify the wireless channels to reduce the Wi-Fi interference:

https://www.tp-link.com/support/faq/2794/

Thank you very much.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:MR 600 with external MIMO Antennas-Solution
2020-09-18 08:44:19 - last edited 2020-09-18 08:45:58

@Moehl_99 

Good day.

Thank you very much for your time and patience.

Sorry for the delay.

For the MR600 v1, It has 2 Detachable External LTE Antennas, and Wi-Fi antennas are internal;

And the LET antennas are RP-SMA male, but normally it is recommended to always use the original antennas and if they have to be replaced, please replace them all together;

 

Since the Wi-Fi antennas are internal, so there is no way to improve the signal by changing the antennas;

But you could try to modify the wireless channels to reduce the Wi-Fi interference:

https://www.tp-link.com/support/faq/2794/

Thank you very much.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 6149

Replies: 1

Related Articles