Disable NAT or not? - WDR3600 in Access Point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Disable NAT or not? - WDR3600 in Access Point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Larrens

2020-10-14 14:06:26 - last edited 2020-10-20 12:16:51

Posts: 8

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-12

Disable NAT or not? - WDR3600 in Access Point mode

2020-10-14 14:06:26 - last edited 2020-10-20 12:16:51

Model: TL-WDR3600

Hardware Version: V1

Firmware Version: 3.14.1 Build 150302 Rel.70490n

I want the WDR3600 router to act as a wired switch for my wired connections. I have configured my router in "access point'' mode. (wireless radio is off)

Setup: Modem - - - Deco (master) - - - WDR3600 AP mode - - - Deco (slave)

I have set the LAN IP in the Deco DHCP range and disabled DHCP server.

Do I also need to disable NAT and disable Hardware NAT or not?

Do I need to change any other settings (eg. firewall) to faciliate this?

Thanks

1 Accepted Solution

Kevin_Z

2020-10-20 12:16:45 - last edited 2020-10-20 12:16:51

Posts: 21755

Helpful: 5137

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:Disable NAT or not? - WDR3600 in Access Point mode -Solution

2020-10-20 12:16:45 - last edited 2020-10-20 12:16:51

@Larrens

Hello, if you want to change the WDR3600 into an access point, it is suggested to disable the DHCP server manually on the WDR3600 as the below guide (Case 2):

https://www.tp-link.com/support/faq/1384/

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Information

Helpful: 0

Replies: 1

Disable NAT or not? - WDR3600 in Access Point mode

Disable NAT or not? - WDR3600 in Access Point mode

Information

Voters 0

Tags