3 unit Powerline P9 Mesh not performing
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a 3 x unit Powerline Deco P9 Mesh, all seem to be connected OK, BUT I have a weak signal and drop outs from the unit furthest away from my router. I just don't know if it's using the power line to connect? Is there a way of checking? Also in the advanced settings, there are VLAN, IPTV and MAC Clone all are Disabled! Should I be using any of them?. BGTW I did disable my router wifi network and set up a Deco wifi network. I'm sure there is something that I have overlooked or got wrong...any suggestions would be gratefully received. My house is a long stone cottage with thick walls; My router comes in at one end (office) where I have set-up unit 1, then the other side of a very thick wall (my lounge) I have set-up unit 2, then beyond another thick wall is my kitchen where unit 3 sits. When I check on the Deco App, I notice that the kitchen Deco unit says its Signal source is the Office (and quite weak), whereas I think this should be getting its signal from the Lounge! Tim
