Deco in separate building out of range

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco in separate building out of range

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco in separate building out of range
Deco in separate building out of range
2021-02-19 02:46:15
Model: Deco M5  
Hardware Version:
Firmware Version:

I am trying to connect an M5 to my current M5 router from a different building that is not in range. The ultimate setup will need to be Modem-Deco-switch-Deco-switch. All hardwired. Do you think that will work or have any suggestions?

  0      
  0      
#1
Options
1 Reply
Re:Deco in separate building out of range
2021-02-19 03:19:32

@Ericd2011 

Hi,

The network topology would be fine.

Since it requires the Ethernet backhaul between Decos and the network switch is needed, some switches could not use to create the Ethernet backhaul, such as D-link switches;

https://www.tp-link.com/support/faq/1794/

Q4: Why my Deco units become unstable once they're connected via a switch?

It's probably that you're using a D-Link switch.

The Deco Ethernet backhaul feature is based on the standard IEEE 1905.1 protocol. However, we find that some D-Link switches will not forward packets based on IEEE 1905.1 protocol, causing all Deco units in a network loop and becoming quite unstable. If you have a D-Link switch and encounter an unstable issue with Ethernet backhaul, we recommend changing the switch to another brand or contact D-Link support directly for a fix.

If you're not sure which switch to use, TP-Link switches may be a good choice.

Thank you very much and wait for your reply.

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 438

Replies: 1

Related Articles