What am I doing wrong with the s4 and a switch for other wired devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have the s4 with 3 units, i hook up my switch to the main s4 ( thats plugged into the router) and it crashes . plug a single device into it and it works. all i want to do is this, Modem>s4>switch with various devices>s4>s4. what am i doing wrong ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
This solution worked for me:
1. Set up Deco S4 + add other S4s to create network
2. Disconnect all Decos except main one by removing power cable
3. Add Ethernet Switch
4. Add each Ethernet cable to switch checking each one works before adding next one
5. Turn other Deco S4s back on (lights go from yellow, to flashing red and back to white when they show up on the app as being reconnected)
I hope that helps you
- Copy Link
- Report Inappropriate Content
I have the exact same issue
I want to add an ethernet switch to the Main Deco s4 but it crashes the set up every time I try
In addition to William_Kohut's set up I have also tried...
Modem>Ethernet switch>Main S4>Other S4s
which doesn't work either
I'm really keen to get a printer and some other stuff connected via ethernet so any help or suggestions would be gratefully received
- Copy Link
- Report Inappropriate Content
Hi,
May I know the model number of your network switch?
What did you mean the Deco S4 crashed, like all the Decos turning red or the internet starting dropping out?
Did the Deco S4 work on the wireless router mode?
Thank you very much and wait for your reply.
- Copy Link
- Report Inappropriate Content
Thanks for your reply @TP-Link
My Decos are S4 not M4
The model number is S4R (EU)
When I attach the ethernet switch to the main Deco, and then connect some devices via the ethernet ports, all three S4 Decos turn red and there is no internet
I then have to reset the Decos to get them working again
Thanks again - looking forward to any suggestions you can offer
- Copy Link
- Report Inappropriate Content
This solution worked for me:
1. Set up Deco S4 + add other S4s to create network
2. Disconnect all Decos except main one by removing power cable
3. Add Ethernet Switch
4. Add each Ethernet cable to switch checking each one works before adding next one
5. Turn other Deco S4s back on (lights go from yellow, to flashing red and back to white when they show up on the app as being reconnected)
I hope that helps you
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 1858
Replies: 4
Voters 1
