WiFi speed stuck at 100mbps on Deco X20
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.WiFi speed stuck at 100mbps on Deco X20
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I notice that i cannot get full speed after replace my maxis router with Deco X20.
My laptop (Qualcomm QCA9377 802.11ac Wireless Adapter) show speed for WiFi is 433Mbps, but when I test using iPerf3, it show transfer rate it below 100Mbps. Distance between Deco and laptop just 2 meter without any wall in between. I should get speed more than that. During the test, i switch off my second M5 Deco which I connect by ethernet backhaul. Please help.
Below I attach screenshot for your referring.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@FreddoFrog please have a check of your message box for more details;
And if anyone had the same issue, here is something you need to confirm:
- In this thread, it is only referred to the limited LAN speed (wired or wireless), the internet speed is not affected or mentioned;
- Did your issue start just after the firmware upgrade?
Then, please leave me a private message with the following details:
- Can I have a picture of your network topology?
- How did you run the iperf test, such as on which devices(model info, adapter info), how are they connected to the Deco?
- The whole iperf speed test results;
Thank you very much.
- Copy Link
- Report Inappropriate Content
I had the same issue too . im using unifi 300mbps speed . Previous im using Deco M5 model . it runs well , speed test was 290mbps sometime 310mbps . great . but once i change to Deco X20 model , the speed test cap at below 100mbps only . then i change back to M5 , 290mbps . after tat i change to Deco X20, i get 80mbps . this is confirm X20 issue . and my Firmware is latest one . how come ?
I get some solution : when i put near to X20 2meter away, then i can get 330mbps . but once i move to 6meter away , it get only 30mbps. this is worse than deco M5 . so regret i bought X20
- Copy Link
- Report Inappropriate Content
Having same issue. After resetting my "homecentral" my ethernet and WIFI signal goes back to 500mbps, but after a few days it drops to 80mbps, sometimes less.
The only solution here is to hard reset the "homecentral", so seems like the central is the problem, but its not. Even when X20 delivers only 80mbps through both ethernet and WIFI, if I just bypass the Deco, my speed is back to 500mbps. Looks like a common problem in here, with no apparent fix yet.
Bought a new house and the deco April this year. Starting to get really annoying.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 7855
Replies: 14
Voters 0
No one has voted for it yet.