Parental Control in new firmware
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good morning,
In the previous firmware version, in the parental control settings, I could set the option of a white list of addresses, i.e. only those addresses to which a given computer in the network should have access. After the update, this configuration has been completely changed. Can I just go back to the older firmware version?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Do you mean Example 2 in the below article? Please check again, and show us the settings menus on your current firmware, we will confirm:
- Copy Link
- Report Inappropriate Content
Yes. This is that case. I have firmware describe in example 2.
- Copy Link
- Report Inappropriate Content
If that is the case, it's suggested to reset the C6 to factory defaults first, reconfigure it from scratch, then confirm again if you can find the correct menu, as we can confirm there is no change for the Parental Control settings compared with the previous version.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 651
Replies: 3
Voters 0
No one has voted for it yet.