Authentication failing for PPPoE on MR200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Authentication failing for PPPoE on MR200
Model:
Archer MR200
Hardware Version: V5
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 210120 Rel.67320n
I am trying to set up the 3G and 4G Backup on my MR200 router by following below link
https://www.tp-link.com/in/support/faq/2719/
But the PPPoE connection always fails with the following message in the log
ppp0 sent [LCP TermReq id=0x3 "Failed to authenticate ourselves to peer"]
I cross-checked ISP provided username/password and the mac address, all seems correct as the same settings works on another router(C6). Tried with a factory reset and followed the same link again but could not get sucess.
Can someone help me in resolving this?
