After enabled wds option in Archer c6 no internet connection shows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

After enabled wds option in Archer c6 no internet connection shows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After enabled wds option in Archer c6 no internet connection shows
After enabled wds option in Archer c6 no internet connection shows
2021-06-08 08:10:13 - last edited 2023-02-01 02:09:24
Model: Archer C6  
Hardware Version:
Firmware Version:

My first router is syroptech dual band and ip is 192.168.1.1..and second is tp-link archer c6 1200 ip is 192.168.0.1..connect both router with Lan...change ip of second router to 192.168.1.2..then disable dchp  and then enable wds bridge..after doing all this no internet connection shows...what to do know plz suggest

  0      
  0      
#1
Options
1 Reply
Re:After enabled wds option in Archer c6 no internet connection shows
2021-06-08 19:14:09 - last edited 2021-06-09 04:57:00

@Nishant1607 

 

Use this guide for configuring WDS on C6. If no internet for the C6 connected devices (wired or wireless) reboot the main router, reboot the C6 after that and test again.

Now you can go to Advanced > Status > Wireless to check the WDS status. When the WDS status is Run, it means WDS bridging is successfully built.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  2  
  2  
#2
Options

Information

Helpful: 0

Views: 2816

Replies: 1

Related Articles