Home Network Community > All Threads > Ability to set 0.0.0.0 as network destination with Static Routring
< All Threads
 
1
Votes

Ability to set 0.0.0.0 as network destination with Static Routring

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
1
Votes

Ability to set 0.0.0.0 as network destination with Static Routring

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Ability to set 0.0.0.0 as network destination with Static Routring
Ability to set 0.0.0.0 as network destination with Static Routring
2021-07-15 17:20:20
Model: Archer AX73  
Hardware Version: V1
Firmware Version: 1.0.1 Build 20200907 rel.76867(4555)

I use this model behind another router, connecting only via the LAN ports.

This way the Archer cannot connect to IP-s outside my LAN.

In any other router, I would set a static routing entry for this problem, to use my main router as gateway for ANY addresses, but here I cannot.

Whats the reasoning behind this? How can it be fixed?

#1
Options
2 Reply
Re:Ability to set 0.0.0.0 as network destination with Static Routring
2021-09-07 11:12:21

@Miberecz 

 

Do you mean the Ethernet connection between the main router and the AX73 is LAN-to-LAN? Did you configure it to work as an access point manually?

 

Try to change the working mode on the AX74 to Access Point, and connect the main router's LAN to the WAN port of the AX73, then check again if the issue persists.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
#2
Options
Re:Ability to set 0.0.0.0 as network destination with Static Routring
2021-09-07 11:58:55

@Kevin_Z 

Yes, I tried that with lan-to-lan.

Yes I tried AP mode, but thats not the point. I want to use network isolation between my two SSID-s, and its only possible without AP mode, but than the router has problems connecting outside of LAN.

#3
Options

Information

Helpful: 1

Views: 1369

Replies: 2

Voters 0

No one has voted for it yet.

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.