Weak signal with ethernet cable plugged in

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Weak signal with ethernet cable plugged in

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Weak signal with ethernet cable plugged in
Weak signal with ethernet cable plugged in
2021-07-22 14:22:14
Model: TL-WA855RE  
Hardware Version: V5
Firmware Version: 1.0.1 Build 200415 Rel.37464n

I've done the setup with it in close proximity to the router. Once done, I've moved it to a position that is on the very edge of the wifi signal but I plugged an ethernet cable in and it won't re-broadcast from the ethernet source, it continuously tries to grab the weak wifi signal and re-broadcast that.

How do I make it broadcast with the ethernet cable?


 

  0      
  0      
#1
Options
1 Reply
Re:Weak signal with ethernet cable plugged in
2021-07-23 03:01:41

@NetTools Hello, 

 

In AP mode, RE will transform the wired network to a wireless one.If you want RE to work as an Access Point, please refer to this instruction to set up an Access Point for RE:
https://www.tp-link.com/support/faq/1401/

 

Factory reset Re before you set it up: with RE power on use a pin to press the reset button until all the Leds flash once

 

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 610

Replies: 1

Related Articles