VR 2800 can't connect to VDSL after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VR 2800 can't connect to VDSL after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR 2800 can't connect to VDSL after firmware upgrade
VR 2800 can't connect to VDSL after firmware upgrade
2021-08-31 12:44:28
Model: Archer VR2800  
Hardware Version: V1
Firmware Version: V1_210313

Hello everyone,

after a firmware upgrade my modem can't connect to the ISP Fastweb. (also available on ISP's available list).

The parameters are the same as before the only change was the firmware.

 

The connection is direct through VDSL.

Contacted the ISP and, from their side, averything looks fine.

 

Tested both quick and normal setup with no success.

 

It is possible to downgrade the software to the previous version?

 

I've tried to upload the old firmware but it was rejected by the Web UI of the modem.

 

Best regards,

Giuseppe

 

 

  1      
  1      
#1
Options
2 Reply
Re:VR 2800 can't connect to VDSL after firmware upgrade
2021-09-02 10:02:31

@Occhipinti 

Hi, did you receive my message, and could you please help me check the required information:

1. A screenshot of the advanced>status(the whole page including Internet and DSL section).

2. A screenshot of the advanced>network>internet

3. Reboot the modem and save the system log after 5-10mins.

Thank you very much.

 

  0  
  0  
#2
Options
Re:VR 2800 can't connect to VDSL after firmware upgrade
2021-09-03 09:15:51

@TP-Link 

Hi TP-Link,
Thank for your answer. 
I will send you the required information ASAP.

 

As update of the current issue, I've currently swapped the modem with the

old one from another competitor brand and the connection works.

 

 

  0  
  0  
#3
Options

Information

Helpful: 1

Views: 729

Replies: 2

Related Articles