Archer MR600 - Offline
Good morning everyone
I have installed an Archer MR600 that controls my home automation and security cameras
I have installed a phone card in the MR600 that always works very well.
With the Tether tool it is very easy to manage and control but it is the 2nd time that the MR600 goes "offline" (Cloud Offile device) and it is no longer possible to access it remotely.
All the devices connected in Wifi are OffLine and the only solution is to turn it off and on again.
can you give me suggestions?
Thanks
Alessandro
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@AlessandroG I have exactly the same problem, sometime the SIM card lost the signal and the only way to go online again is to reboot, if nobody at home to reboot you're cut out!
Firmware Version: 1.4.0 0.9.1 v0001.0 Build 210727 Rel.33453n
Hardware Version: Archer MR600 v2 00000002
- Copy Link
- Report Inappropriate Content
Hello Tks for answer
I will check my firmware and decide. how to proceed
I will define a automatic reboot every week and check the situation.
I will update you
Alessandro
- Copy Link
- Report Inappropriate Content
@AlessandroG yeahhh, I done the same 6:30 in the morning, automatic reboot, but you don't know when the provider line is cut, If cut at 6h35 the problem persist until I reboot. I think this is TP-LINK router problem, I have a second router ( Cudy LT400 ), no problem after provider line cut, when the line is on also the router come again up without reboot, the cudy router problem is only 4G and not 4+G , the difference between 4 and 4+ is too much.
bought a new one, ( Tenda Routeur 4G09 AC1200 Bi-bande 4G + Mobile Routeur ) arrives tomorrow, let you know ;-)
- Copy Link
- Report Inappropriate Content
Hi, I see your hardware is V2 and if possible, you could also install the following firmware to have a look:
https://static.tp-link.com/upload/beta/2021/202112/20211206/Archer_MR600(EU)_V2_210914.zip
- Copy Link
- Report Inappropriate Content
@TP-Link Thank you, why this version of Firmware isn't on the Support download page? ( beta?)
I already check about new Firmware, but the router itself wrote "Your Firmware is up to date " and on the Download page tp-link the newest is Archer MR600(EU)_V2_210208
Done your Firmware update, wait for provider cut to let you know
Thank you
- Copy Link
- Report Inappropriate Content
@TP-Link this Firmware see now the router Internet line offline, but not solve the problem, must reboot to have the Provider Line up and running.
Change it with another router, work fine ;-)
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2115
Replies: 6
Voters 0
No one has voted for it yet.