AX5400 One mesh option

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX5400 One mesh option

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX5400 One mesh option
AX5400 One mesh option
2022-01-13 23:11:47
Model: Archer AX73  
Hardware Version: V1
Firmware Version:

Hi there, I can’t seem to find this in the instruction manual...

 

if I don’t have any repeaters or access points, should I turn off the One Mesh option? It is enabled by default.

 

are there any pros or cons of disabling it?

 

ta

  0      
  0      
#1
Options
1 Reply
Re:AX5400 One mesh option
2022-01-14 00:43:49

@Hughseee 

 

Go through this thread and decide for yourself.

My general rule is - if you don't use it then turn it off.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 551

Replies: 1

Related Articles