MR600 V2 Carrier Aggregation normal or
Hello,I recently acquired that model after reading the reviews of customers.
Now my question is this:
Is it normal for the band on the status to show ONLY band 7 when I have selected bands 7 AND 3 on the router.
pictures are following
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
The following reasons might cause the failure of B3+B7 carrier aggregation.
1. the selected bands under manual band selection will list all the 4G bands that our modem is able to use in the current network. Some of them might be not from your SIM carrier.
2. The SIM carrier might support B3 and B7 but it did not support carrier aggregation of these two bands.
In this way, May I know who is your SIM carrier?
if possible, are you able to test on a different 4G router or put the SIM card into the smartphone and check whether they could use B3+B7 at the same time?
Thank you very much.
- Copy Link
- Report Inappropriate Content
hello and thank you for the answer.My Carrier is Cosmote in Greece.My iphone13 connects to band 20 when tested in the same room as the router.
How can I manually check on my phone if the bands can be aggregated as you suggested?
as for another 4g router this option is not available at the moment
Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 1013
Replies: 4