Greetings community,

I just upgraded to the Deco x60 and cannot use my Pi-Hole as I have used with my previous setup.

Here's what I've tried:

1. Following the steps in https://www.tp-link.com/us/support/faq/3230/ I have successfully made the advised changes in the DHCP server section and am still unable to direct DNS traffic to my Pi-hole device.

2. Looking deeper I found in Advanced > IPv4 > Internet Connection Type, there is an enabled switch "Obtain DNS Automatically".  Disabling this switch opens the primary and secondary DNS fields, when I attempt to set primary DNS to my Pi-hole I get the following error: "This IP conflicts with the LAN IP subnet. To use this DNS Server, set it as DHCP Server." with that, setting the Primary DNS field to the DHCP server gives me the same error.  This error occurs even if I clear the DNS entries in the DHCP server section.

Alternatively, the Pi-Hole does have the option to function as a DHCP server in addition to DNS, I do not see an option to disable DHCP server in the Deco.  Perhaps I need to change the Operation Mode to Access Point?

Thank you for reading, if you have any suggestions I would greatly appreciate it.  Also, let me know if you need additional information.