I recently bought a pack of 3 X60's (Ver 1). 

So far I have only set up one unit as the main unit (I'm moving houses and keeping the rest in the box for now).

I have it running with the default config, no QoS, no Antivirus/filtering options enabled. 

 

So all of the below relates to a single main X60 unit.

 

I have a stable internet connection (1 Gigabit down, 500mbps up). 

Previously I was using Deco M9s without issue. 

 

An issue that has cropped up, is that the Wifi speed occasionally becomes very slow for devices, and the only way to resolve it to hard-reboot the Deco. 

 

As an example:

- Speed tests performed by my iPhone 13 and/or Macbook Air consistently show 450mbps, with multiple tests throughout the day

- Then after a couple hours, Wifi to internet speeds slow down considerably (sometimes to 80mbps, sometimes 10mbps).

- At this point, doing a 'internet speed test' in the Deco app shows my full internet speed. 

- The only way to resolve the issue is then to hard-reboot the unit. 

- I have tried using the other units as the primary.

- I have tried another factory reset of the unit.

 

All tests performed while standing directly next to the unit. 

Confirmed with a wifi scanning program on my laptop that I am not getting any channel interference from my neighbour. 

 

Looking through the logs, I see some errors cropping up occasionally, below is an extract showing logs for my iPhone (filtered by MAC):

--------
Sat Aug 27 06:28:45 2022 daemon.err nrd[11324]: estimatorCmnHandleBeaconReportEvent: Invalid beacon report for F8:C3:CC:28:54:22
Sat Aug 27 06:28:51 2022 daemon.err nrd[11324]: triggerMonSteering: Failed to get uplink rssi for F8:C3:CC:28:54:22
Sat Aug 27 06:28:51 2022 daemon.err nrd[11324]: estimatorCmnHandleBeaconReportEvent: Invalid beacon report for F8:C3:CC:28:54:22
Sat Aug 27 06:28:57 2022 daemon.err nrd[11324]: triggerMonSteering: Failed to get uplink rssi for F8:C3:CC:28:54:22
Sat Aug 27 06:29:51 2022 daemon.err nrd[11324]: estimatorCmnHandleBeaconReportEvent: Invalid beacon report for F8:C3:CC:28:54:22
Sat Aug 27 06:29:57 2022 daemon.err nrd[11324]: estimatorCmnHandleBeaconReportEvent: Invalid beacon report for F8:C3:CC:28:54:22
Sat Aug 27 06:30:03 2022 daemon.err nrd[11324]: triggerMonSteering: Failed to get uplink rssi for F8:C3:CC:28:54:22
Sat Aug 27 06:30:06 2022 daemon.err nrd[11324]: estimatorCmnHandleBeaconReportEvent: Invalid beacon report for F8:C3:CC:28:54:22

---------

 

1) Do these logs suggest anything? 

2) I've read reports that the V1 of the X60's have issues, am I better off trying to get a later hardware version?

3) Should I give up and go back to the M9s?

 

@Support - Willing to try beta firmware to get this resolved.

 

Thanks,

Alex