USB Storage device - Not showing the right ip address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

USB Storage device - Not showing the right ip address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
USB Storage device - Not showing the right ip address
USB Storage device - Not showing the right ip address
2022-09-22 20:08:12
Model: Archer AX50  
Hardware Version: V1
Firmware Version: 1.0.11 Build 20210730 rel.54485(5553)

Hi every one

 

I can't acces my USB Sharing device from outside. In my config, the FTP(via Internet) is not showing the right IP. My local FTP is : ftp://192.168.0.1:21, but the other show :  ftp://192.168.2.10:2121  My router is connected on my Bell internet that is also a router. So i think that my archer is only viewing the IP from the Bell Router. Do you have any advice for me ? 

 

 

Thanks. 

 

  0      
  0      
#1
Options
1 Reply
Re:USB Storage device - Not showing the right ip address
2022-09-22 20:27:12 - last edited 2022-09-22 20:31:14

  @MDavid 

 

You probably are behind a double NAT because of the two routers in series.

A possible solution is to use the Bell Router in bridge pome (if possible) to avoid teh double NAT and receive your public IP address on the AX50 WAN port.

If that's not possible you can configure AX50 in AP mode (Case 1), which should avoid the double NAT as well.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 544

Replies: 1

Related Articles