Home Network Community > All Threads > Deco M4R ridiculously slow speed.
< All Threads

Deco M4R ridiculously slow speed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M4R ridiculously slow speed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M4R ridiculously slow speed.
Deco M4R ridiculously slow speed.
2022-10-04 03:02:29
Model: Deco M4  
Hardware Version: V2
Firmware Version: 1.5.5 Build 20220823 Rel. 41353

I am having trouble with 1 of my mesh. My set up is just 2 mesh in a 90sqm house with 2nd floor.

The one having trouble is the one I placed in our stairs.

Facts:

  • The location of mesh in the stairs have a full bar 5G signal
  • It's outputting only 2.4G
  • Very slow connection and constantly disconnecting

 

I did troubleshoot and here are the steps:

  1. Reset both mesh
  2. Connect the Stairs mesh (problematic) directly to internet via the provided cable
  3. Test network connection: 9.27 Mbps
  4. Remove the Stairs mesh and tried the other one. Connect the other mesh directly to internet via the provided cable
  5. Test network connection: 200.62 Mbps.

 

 

 

Details about the device:
AC1200 Whole Home Mesh Wi-Fi System

Model: Deco M4R(US) VER: 2.0

Firmware: 1.5.5 Build 20220823 Rel. 41353

SSID Deco_A4D8

  0      
 
  0      
 
#1
Options
1 Reply
Re:Deco M4R ridiculously slow speed.
2022-10-14 09:55:33

  @cian 

Thank you very much for your time and patience.

When I checked your TP-Link ID, I see the main Deco is on 1.5.5 and the satellite M4 is on 1.1.9 Build 20200119 Rel. 75362. Based on the previous feedback, it is a local ISP-customized firmware for PLDT. So did you get these 2 units separately, one bought by yourself and the other provided by ISP directly?

Are you able to replace the Deco M4-1.1.9 the customized version with a general version?

 

As for the issue mentioned here:

Facts:

  • The location of mesh in the stairs has a full bar 5G signal
  • It's outputting only 2.4G
  • Very slow connection and constantly disconnecting

Were you trying to say the upstairs satellite M4 is only broadcasting 2.4ghz?

 

Thanks a lot.

Best regards.

 

 

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶Deco X50-5G-V1-1.2.0 Supports WireGuard VPN, Hybrid Mesh and More Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 605

Replies: 1

Related Articles
Deco M4r slow speed
503 0
Slow speed with Deco M4R
1111 0
Connection ridiculously slow
483 0
Deco M4 and M4R
981 0
Deco M4R V2
940 0
DECO M4R backhaul speed question
315 1
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.