RE305 stopped working after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE305 stopped working after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE305 stopped working after firmware upgrade
RE305 stopped working after firmware upgrade
2022-12-11 14:07:28

I updated the range extender RE305 using the Tether app. Once completed, it didn't start again. When I plug it in, all four lights go blue for a second, then the signal light goes red for a second, ending up with only the power light being blue and all other lights out. 
I've tried to reset button several times, even holding it for 20 seconds, but nothing changes. 
How do I make it work again?

 

 

  0      
  0      
#1
Options
2 Reply
Re:RE305 stopped working after firmware upgrade
2022-12-13 07:27:59

  @Perry_182 

Hi, may I know how long have you had the RE305?

And would the power LED go off then back on or would there be any change to the LED lights during the factory reset?

Have you noticed anything abnormal during the firmware upgrade?

Wait for your reply.

Best regards.

 

  0  
  0  
#2
Options
Re:RE305 stopped working after firmware upgrade
2022-12-16 21:54:39

  @David-TP 

I had it for about two years.

When I press the rest button nothing happens with the lights.

the update went well, it counted down to 100%, but when it was done it never worked. So I guess it actually didn't work at all. 
is there a way to undo the update?

  0  
  0  
#3
Options