Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > How do I get access to TL-WR802N in client mode?

< All Threads

How do I get access to TL-WR802N in client mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How do I get access to TL-WR802N in client mode?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Stephen3232

2023-03-04 09:20:42

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-04

How do I get access to TL-WR802N in client mode?

2023-03-04 09:20:42

Tags: #Port Forwarding

Model: TL-WR802N

Hardware Version:

Firmware Version:

I have connected a door controller to my Wifi via my TL-WR802N. The door controller gets the IP 192.168.188.123 from my router (Fritzbox). I can access this door controller without any problems. Now I want to access my TL-WR802N again via Wifi. This is set up in client mode. But I don't see the TL-WR802N in my network overview in the router? What can I do? Apart from going there and connecting a PC to it again?

1 Reply

woozle

LV5

2023-03-04 14:27:34

Posts: 2903

Helpful: 1930

Solutions: 519

Stories: 0

Registered: 2020-05-01

Re:How do I get access to TL-WR802N in client mode?

2023-03-04 14:27:34

@Stephen3232

Hi,

If you want to be sure you always know the correct IP address of the TL-WR802N, then during setup configure its LAN IP address as "Static IP" instead of "Smart IP(DHCP)". Just choose any IP address from the same subnet as the Fritzbox that is not already in use by another device and also is outside of the Fritzbox's DHCP address pool.

Stephen3232

2023-03-04 09:20:42

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-04

Information

Helpful: 0

Replies: 1

How do I get access to TL-WR802N in client mode?

How do I get access to TL-WR802N in client mode?

Information

Voters 0

Tags