Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > CPE510 which mode to use extending mesh network

< All Threads

CPE510 which mode to use extending mesh network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 which mode to use extending mesh network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 which mode to use extending mesh network

2023-03-11 17:20:24

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-11

CPE510 which mode to use extending mesh network

2023-03-11 17:20:24

Model: Deco PX50

Hardware Version:

Firmware Version:

Hi I'm hoping someone can help. I would like to extend a signal from a Deco PX50. I was hoping to receive the wifi signal into a CPE510 and then hardwire the signal from the CPE510 into another Deco PX50. Not sure which mode to use and how to configure through Pharos.

0

0

#1

1 Reply

2023-03-13 11:36:33 - last edited 2023-03-13 11:42:09

Posts: 12857

Helpful: 1810

Solutions: 1298

Stories: 9

Registered: 2020-04-14

Re:CPE510 which mode to use extending mesh network

2023-03-13 11:36:33 - last edited 2023-03-13 11:42:09

Hi, welcome to the community.

If possible, it is suggested to use 2*CPE510 to create an AP-client bridge connection:

How can I set up the AP + Client topology successfully?

Common Applications for Pharos Products

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

0

0

#2

2023-03-11 17:20:24

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-03-11

Information

Helpful: 0

Views: 403

Replies: 1