wrong firmware updated wpa4220

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

wrong firmware updated wpa4220

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
wrong firmware updated wpa4220
wrong firmware updated wpa4220
2023-05-02 18:07:24
Model: TL-WPA4220 KIT  
Hardware Version: V5
Firmware Version:

at the place of updating tl-wpa4220 kit i updated tl-wpa4220 but when i update it it say update failed or something but i said it failed after that my tp link wifi doesn't show on the wifi list and there always two led blinking im using ethernet for fixing it using pcl recover but it could not detect so anyone please help me!

  0      
  0      
#1
Options
2 Reply
Re:wrong firmware updated wpa4220
2023-05-05 03:49:33

  @msi_mortal 

 

The two LEDs light up on WPA4220 are power and WiFi or power and ethernet? 

Please try to reset the WPA4220 to factory defaults by holding reset button for about 10s until power LED starts flashing.

 

If WiFi LED is still off, please try to press WiFi button(the WiFi LED is also a button) for 5s to enable WiFi to see if it will light up.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:wrong firmware updated wpa4220
2023-05-09 09:29:23

  @Sunshine I tried but it doesn't work so i sended to repair

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 442

Replies: 2

Related Articles