2.4G band is weak

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2.4G band is weak

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
2.4G band is weak
2.4G band is weak
2023-07-20 11:56:01 - last edited 2023-07-20 12:00:30
Tags: #Device Performance
Model: Archer C60  
Hardware Version: V3
Firmware Version: 1.2.0 Build 20201231

I am using this router for less than a year. The 2.4G band's speed is too weak. I can use the 5G band with great speed from 3 rooms away. But in the case of the 2.4G band, I can only use this in the room where the router is set up. If I go to the next room, the speed goes way below usable speed. Is there any solution to this problem?

  0      
  0      
#1
Options
1 Reply
Re:2.4G band is weak
2023-07-25 07:58:34

  @zakariahmed 

 

Usually there is much interference on 2.4G band, which will affect the 2.4G speed, and 5G supports higher link rate, thus 5G band is usually much faster than 2.4G band.

 

You could try changing the 2.4G Wi-Fi channel and channel width on Advanced->Wireless->Wireless Settings page to see if it can be improved.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 266

Replies: 1

Tags

Device Performance
Related Articles