This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unit will not connect to my MESH network by wi-fi or cable. Upon startup, or after a reset, it displays yellow, then blue which immediately starts flashing and continues non stop. MESH network consists of an X20 Ver. 1.20 as router and a secondary X20 Ver. 2.0 backhauled by ethernet. All working fine. What should I do next? Ron
Hi, have you tried to manually add this unit on the Deco APP by clicking "+"> Add a Deco unit?
If it fails again, can I have a picture of the error message on the Deco APP?
After that, could you please help me run the following test:
1. switching the Deco X20_V2 as the main Deco.---How to Set up the Satellite Deco or a new Deco to be the Main Deco
2. try to add the other satellite Deco X20_V2 again on the Deco APP.
By the way, I noticed the current firmware of your Deco X20_V2 is on 1.0.3. The latest firmware for Deco X20_V2 is 1.2.3 Build 20230906.
It is also suggested to manually update the firmware to the latest version via web UI first:
Deco X20(US)_V2_1.2.3 Build 20230906
How to Update the Firmware of Deco
Thank you very much and best regards.
Thanks for your assistance. Several months since I have changed anything and so was out of touch with the process.
I have successfully added the Deco X20 Ver. 2, updated all three units to latest available firmware and everything is working well.
I have not yet tried to make the satellite Deco the main Deco as you suggested because it looks a little complicated and I shall postpone that exercise until I can devote the necessary undivided attention to it.
Ron
Helpful: 0
Views: 337
Replies: 2
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
