RE220 Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE220 Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE220 Issue

DRobC

2023-12-09 15:59:23 - last edited 2024-01-29 03:39:07

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-12-09

RE220 Issue

2023-12-09 15:59:23 - last edited 2024-01-29 03:39:07

Model: RE220

Hardware Version:

Firmware Version:

After months of good performance, it has stopped working. The power light settles for a few seconds before continuing to blink. Then, all lights flash before the power light starts blinking again, and the same cycle repeats itself. Attempts to reset have not been successful. How can I reprogram it? Thanks.

1 Accepted Solution

David-TP

2023-12-13 01:39:57 - last edited 2024-01-29 03:39:07

Posts: 12350

Helpful: 1709

Solutions: 1118

Stories: 9

Registered: 2020-04-14

Re:RE220 Issue-Solution

2023-12-13 01:39:57 - last edited 2024-01-29 03:39:07

@DRobC

Update:

Please refer to the following solution:

RE220/RE200/RE190 Keeps Restarting Automatically

Best regards.

Check What's Currently Going on With Deco Deco Early Access Firmware Open for Test! Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.

Recommended Solution

6 Reply

Brian527

LV1

2023-12-11 01:40:34

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-12-11

Re:RE220 Issue

2023-12-11 01:40:34

I have the same problem. It just keep cycling between solid and flashing power led. Pushing the reset pin does nothing but start the cycle over again.