WAN Port
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WAN Port is not detecting (1000mbps Full Duplex).
When I connect ethernet cable in auto negotiation mode it was detecting only (100mbps Full Duplex).
I tried to change from auto negotiation to (1000mbps Full Duplex) its shows no ethernet cable was connected.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Behappy07 Did you check if your cable connector has 8 wire instead of 4?? gigabit lan requires 8 internal wire, instead of the 100 fast ethernet that can work with only 4 wire crimped in its rj45 connector... check it:
- Copy Link
- Report Inappropriate Content
Yeah my ethernet connector have 8 individual wire and it was properly crimped.
Even aslo I was checked in my another Wi-Fi router it was successfully detected 1000mbps.
- Copy Link
- Report Inappropriate Content
This is usually an ethernet cable issue caused by crimping. Try with a different cable (good quality, factory made - like the one in C6 kit).
- Copy Link
- Report Inappropriate Content
How to check my WAN Port is damaged or not. I don't have any ethernet supported devices I have only wireless devices. I have only one ethernet cable coming from the isp.
- Copy Link
- Report Inappropriate Content
If your other router is a gigabit one, then you can use the cable from the C6 kit to connect other router LAN port to C6 WAN port and observe its negotiated speed.
- Copy Link
- Report Inappropriate Content
@terziyski I tried that but unfortunately the negotiation speed didn't not change to (1000mbps Full Duplex) if I force to change the settings from auto negotiation to 1000mbps it's show no ethernet cable was connected & Internet LED light also not glowing. I think my WAN Port is damaged 🥲 And my router is 3 months old only 😐
- Copy Link
- Report Inappropriate Content
If nothng works for you then contact your local tech support for further assistance - here.
- Copy Link
- Report Inappropriate Content
The WAN Port is the culprit for this issue and now the issue was resolved by TP Link Service Center they just replace my faulty router to newer one.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1392
Replies: 8
Voters 0
No one has voted for it yet.